Table of Contents
Advertisement
Introduction
1
Connector
Function
The power reference is a 1 mW (0 dBm) 50 MHz signal available from a 50 Ω type-N
connector. It is used for calibrating an 8480 or E-Series power sensor and meter
system. If the meter is configured with Option C03, the connector is fitted to the rear
panel. The Green LED beside the connector is lit when the calibrator is turned on.
The sensor input connectors (N1914A shown, the N1913A has one input). If the
meter is configured with Option C02 or C03, the connectors are fitted to the rear
panel and the front panel connectors are retained.
If the meter is configured with Option 201, one USB Type A port is fitted to the front
panel (Channel C) and another Type A port (Channel D) to the rear panel.
Keysight N1913/1914A User's Guide
33
Advertisement
Table of Contents
