Table of Contents
Advertisement
b.
Option 2: Configure Network Port 1 with an IPv6 Address
3.
a.
b.
Configure the Library Step 3 of 6: Set the Library Date and Time
The third step of library initialization is to set the library date and time.
Set the library time zone:
1.
a.
b.
c.
Configure the date and time by selecting either Manually or Using Network Time
2.
Protocol from the list.
■
■
Verify the values are correct (change any incorrect value by tapping the keyboard
3.
button). Tap Next.
Verify the values are correct (you can change any incorrect value by tapping
the keyboard button). Tap Next.
Use the Configure IPv6 list to select DHCPv6, Stateless (SLAAC), or Static.
–
If you select the DHCPv6 option, for a successful startup, DHCPv6 must
be running on your network.
–
If you selected Static, you must enter the IPv6 Address, Prefix Length, and
Gateway.
Verify the values are correct (you can change any incorrect value by tapping
the keyboard button). Tap Next.
Select the Time Zone from the list.
Select the Closest City or Region from the list.
Tap Next.
If you select Using Network Time Protocol, you must provide the IP address
of a Network Time Protocol server on your network. The steps are similar to
those for setting an IP address for Network Port 1.
If you select Manually, enter the current date in the format MM/DD/YYYY.
Enter the current time in the format HH:MM:SS where HH represents 24-hour
format.
Configure the Library After Powering-on for the First Time
Installing the Library 2-33
Advertisement
Table of Contents
