Extended Current Controller; Torque Controller - BONFIGLIOLI ACTIVE Cube ACU 201-01 Operating Instructions Manual

Frequency inverter 230 v / 400 v 0.25 kw ... 132 kw
Table of Contents

Advertisement

17.5.2 Extended Current Controller

For some machines it might be necessary, that for different current ranges different
Amplification factors must be set up.
The following classification applies:
Current <
Current above P. 700 is in effect
>
Current >
rent
By default, the parameters are pre-assigned so that the parameters are not active
and only the basic parameters are active.
No.
757 Current below P. 700 is in effect
758 Current above P. 759 is in effect
759 Amplification high Current
775 Current above P. 700 is in effect
776 Current below P. 777 is in effect
777 Amplification low Current
I
= Nominal Output current of Frequency inverter
FIN
o: Overload capability of Frequency inverter
The motor autotuning changes the parameters.

17.5.3 Torque Controller

The torque-controlled configurations 230, 430, 530 and 630 can be used for sensor-
less torque control alternative to the speed control. The torque control is usable
above the
sion is active with the current reference frequency as reference value. In this case
the torque is not controlled, but results depending on the load and the
623. To achieve a starting in torque control, the reference frequency should be
rent
set higher than
imum frequency
f <
Frequency Limit
f ≥
Frequency Limit
The
Frequency Limit
Operating Instructions ACU
06/13
Current below P. 777 is in effect
Amplification low Current
Current below P. 700 is in effect
Current above P. 759 is in effect
759
Parameter
Description
624. Below the
Frequency Limit
624. This is guaranteed in example by setting
Frequency Limit
418 >
Frequency Limit
624: Current impression
624: Direct Torque Control
624 is set automatically during the motor setup.
776
777
775 > Current
757 
Amplification
758 
Amplification high Cur-
Settings
Min.
Max.
0.00
o * I
FIN
0.00
o * I
FIN
0.00
8.00
0.00
o * I
FIN
0.00
o * I
FIN
0.00
8.00
624 the current impres-
Frequency Limit
624.
700
Fact. sett.
o * I
FIN
o * I
FIN
0.00
0.00
0.00
0.00
Starting cur-
Min-
229

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ACTIVE Cube ACU 201-01 and is the answer not in the manual?

Questions and answers

Владимир
February 17, 2025

Конфигурация 610 контроллером крутящего момента. Опорный крутящий момент представлен в видепроцент и он передается в соответствующие эксплуатационные показателиприложение. Переключение между регулированием переменной скорости и регулированием крутящего моментаУправление осуществляется без рывков во время работ? Как подробнее узнать об этом режиме? Нужно обеспечить останов с заданным моментом на валу мотора

Table of Contents

Save PDF