Quitting Commissioning; Selection Of An Actual Value For Display - BONFIGLIOLI ACTIVE Cube ACU 201-01 Operating Instructions Manual

8.2.11 Quitting commissioning

Confirm the "End" display by pressing the ENT key.
The guided commissioning of the frequency inverter is terminated via a reset and
the initialization of the frequency inverter. The relay output X10 signalizes a fault,
because of the factory setting
Signal" (Inv: inverted).
After successful initialization of the frequency inverter, the factory-set parameter
Actual frequency
The drive is accelerated to the set
configurations 110, 111, 410, 411, 430 or to 0.00 Hz in configurations 210, 211,
230, 510) by:
signals at digital inputs S1IND/STOA and S7IND/STOB and
•
Start clockwise by rising signal edge at S2IND or
•
Start anticlockwise by rising signal edge at S3IND
Status signals
160 - Ready Signal
1 -
161 -
2 -
162 -
3 -
1)
For linking with inverter functions
2)
For digital output

8.2.12 Selection of an actual value for display

After commissioning, the value of parameter
the control unit KP500.
If another actual value is to be displayed after a restart, make the following settings:
• Use the arrow keys to select the actual value to be displayed as from now.
Use the ENT key to display the value of the parameter.
•
Press the ENT key again. "SEt" is displayed for confirmation.
•
As from now, the selected actual value is displayed after each restart.
If the parameter settings were made via the optional control software or in the PARA
menu branch of the operating unit, the display of the selected actual value must be
activated manually. Use the ESC key to switch to the selection of the actual value for
display again.
112
Op. Mode Digital Output 3
241 is displayed.
Indicates initialization and operating readiness of the
1)
inverter.
Ready or Indicates initialization and operating readiness of the
2)
Standby Signal inverter.
Indicates enable and start command (output frequen-
1)
cy available).
Run Signal
Indicates enable and start command (output frequen-
2)
cy available).
1)
Monitoring function signalizes a fault with display in
Error Signal
2)
parameter
Operating Instructions ACU
532 = "103 - Inv. Error
418 (factory setting 3.50 Hz in
min. frequency
259.
Current Error
Actual frequency
241 is displayed at
06/13