BONFIGLIOLI ACTIVE Cube ACU 201-01 Operating Instructions Manual page 181

Operation mode 530,532,554
22 - Warning V-belt
23 - Timer 1
24 - Timer 2
25 - Warning Mask
26 - Warning, Application
27 - Warning Mask, Application
Warning, gen + Warning,
28 -
Application
Warn. Mask, gen + Warn.
29 -
Mask, Appl.
30 - Flux-Forming finished
41 - Brake release
43 - External Fan
50 - Synchronization Fault
51 - Signal Fault
56 - Phasing Done
57 - In Gear
58 - Position comparator
59 - Homing Done
60 - Target Position Reached
Warning Deviation of Posi-
61 -
tion
Motion-Block Digital Sig-
62 -
nal 1
Operating Instructions ACU
06/13
1)
1)
2)
1) 2)
2)
2)
2)
2)
Function
Warning of
Operation Mode
toring.
The selected
Operation Mode Timer 1
erates an output signal of the function.
The selected
Operation Mode Timer 2
erates an output signal of the function.
Message of the configurable parameter
536.
Warning Mask
Warning application is signaled. Display of the
actual value is affected via parameter
273.
Application
Message of the configurable parameter
Warning Mask Application
Warning or warning application is signaled.
Message of configurable parameters
536 and
Warning Mask
626.
Application
Magnetic field has been impressed.
Activation of a brake unit depending on the
620 for the starting behavior,
eration Mode
630 for the stopping behavior or
eration Mode
the configured brake control system.
The
Switch-On Temperature
reached.
The phase error of the index control exceeded
597.
the
Warning limit
Index signal period too short during index con-
trol.
Message of phasing function. For positioning in
combination with the function of the electronic
gear, the value
Phasing: Offset
reached.
Synchronization of the electronic gear is reached.
The slave drive is engaged and operates at a
synchronous angle with the master.
The current actual value is in the range between
1243 and
Switch-on position
1244 of the position comparator. The adjusted
value of the parameter
Hysteresis
sidered.
A reference travel operation was started and the
reference position for positioning was set.
469 of axle positioning
Reference orientation
was reached or
Target position / Distance
2)
ing operation was reached (the current act.
position is within the range set in parameter
1165 for a minimum period of
Target window
1166).
Target window time
The contouring error monitoring
1105 was exceeded.
Threshold
Message on status of a travel order during a
positioning operation. The conditions set for pa-
rameter
Digital Signal 1
"Start", "Reference value reached" and "End" of a
travel order were evaluated.
581 of V-belt moni-
790 gen-
793 gen-
Create
Warnings
Create
626.
Create
Create Warning Mask
Op-
Op-
39 has been
1125 was
Switch-off position
1245 is con-
1202 of a position-
Warning
1218 were fulfilled.
181