Digital Outputs - BONFIGLIOLI ACTIVE Cube ACU 201-01 Operating Instructions Manual

15.3

Digital Outputs

The
Operation mode Digital output 1
Operation mode Digital output 3
The selection of the functions depends on the parameterized configuration. The use
of the multifunctional output MFO1 as a digital output demands selection of an
ation mode
Operation mode 530,532,554
0 - Off
1 - Ready or Standby Signal
2 - Run Signal
3 - Error Signal
4 - Setting Frequency
Reference Frequency
5 -
reached
Reference Percentage
6 -
Reached
7 - Ixt warning
Warning
8 -
Heat sink temperature
Warning
9 -
Inside temperature
10 - Warning Motor Temperature
11 - Warning General
12 - Warning overtemperature
13 - Mains Failure
Warning Motor Protect.
14 -
Switch
15 - Warning Current Limitation
Controller Current Limit.
16 -
Long Term Ixt
Controller Current Limit.
17 -
Short Term Ixt
18 - Controller Current Limit. TK
Controller Current Limit.
19 -
Motor Temp.
20 - Comparator 1
21 - Comparator 2
180
532 link the digital outputs to various functions.
550 and linking via parameter
Digital output is switched off.
Frequency inverter is initialized and on stand-by
or in operation.
Signal enable STO (S1IND/STOA and
S7IND/STOB) and a start command are present,
output frequency available.
Message is displayed via the parameter
error
The
parameterized
The
reached the
The
erence percentage
The
ing Limit Long-Term Ixt
Max. heat sink temperature T
the
reached.
Max. inside temperature T
Warning Limit Inside Temp.
Warning behavior according to parameterized
Operation mode Motor temperature
motor temperature T
The message is displayed via parameter
ings
The selected limit values
Sink Temp.
408 or the maximum motor temperature has
been exceeded.
Failure of the mains voltage and power regula-
tion active according to
the voltage controller.
Parameterized
tor protection switch has triggered.
A controller or the
intelligent current limits limits the output current.
The overload reserve for 60 s has been used up
and the output current is being limited.
The overload reserve for 1 s has been used up
and the output current is being limited.
Max. heat sink temperature TK reached, intelli-
gent current limits of
tive.
Max. motor temperature reached, intelligent cur-
rent limits of
The comparison according to the selected
eration mode Comparator 1
The comparison according to the selected
eration mode Comparator 2
Operating Instructions ACU
530 and the relay output with the parameter
Digital operation MFO1
Function
259 or 269.
Warnings
210 is higher than the
Stator frequency
Setting frequency
241 of the drive has
Actual frequency
Internal reference frequency
230 has reached the
Actual percentage
229
.
Warning Limit Short-Term Ixt
406 has been reached.
Warning Limit Heat Sink Temp.
of 65 °C minus the
i
.
PTC
269.
Warning Limit Heat
407,
Warning limit Inside Temp.
Operation Mode
Operation Mode
Operation Mode
Operation mode
Operation Mode
Oper-
554.
Current
510
228.
Ref-
405 or
Warn-
of 80 °C minus
K
407
408 reached.
570 at max.
Warn-
670 for
571 for the mo-
573 of the
573 ac-
573 active.
Op-
540 is true.
Op-
543 is true.
06/13