BONFIGLIOLI ACTIVE Cube ACU 201-01 Operating Instructions Manual page 217

Via parameter
halted. The P and D part remain at the value before switching off. The output value
and the I part resets with each switching off of the
58.
The default assignment of parameter
technology controller must be observed:
Start Clockwise
This assignment may not be changed. The technology controller becomes active with
the controller release at digital input S1IND/STOA.
Structural image: Inputs for reference percentage source
S2IND
S3IND
S6IND
MFI1
The function selected via the parameter
the technology controller.
Operation mode
0 - off
1 - Standard
2 - Liquid Level 1
3 - Liquid Level 2
4 - Speed Controller
Indirect Volume Flow
5 -
Control
Operating Instructions ACU
06/13
Technology Controller Release
68 = 13 - Technology Controller Start.
Actual Percentage Source
Repetition Frequency
Input
0
0
f
%
1
Operation mode
496
Devider
497
0
Multifunctional Input
analog
1
digital
Operation mode
452
440
The technology controller is switched off; the refer-
ence value specification is done via the reference
percentage channel.
For pressure and volume flow control with linear op-
erating behavior and actual value monitoring.
Contents level control at defined motor speed with
actual value missing.
Contents level control at defined motor speed with
actual value missing or high control deviation.
Speed control with analog feedback of the actual
speed.
Volume flow control with square rooted actual value.
58 the technology controller can be
Technology Controller Release
68 to the logic signal of the
Start clockwise
Technology Controller
478
F3
MFI1A
+
440 defines the behavior of
Operation mode
Function
Actual values
Istwerte:
Actual Percentage Value
230
217