Handshake Traverse Function; User Warning; External Error - BONFIGLIOLI ACTIVE Cube ACU 201-01 Operating Instructions Manual

15.4.10

Handshake Traverse Function

Via parameter
specification of the direction of rotation of the slave drive of the shot-effect function.
The shot-effect function is switched on via parameter
15.4.11

User warning

For setting up external warnings parameters
1364 can be used. Parameterization of a user warning enables triggering a
ing 2
warning in the device via a digital signal if a critical state in the plant occurs. The
warning is displayed in
er-level control like a PLC. Please check parameter
626 and chapter 15.3.9 „Application warning mask" for further explanations
15.4.12

External error

Parameterization of an external error enables switching off or shutting down several
frequency inverters at a time if a fault occurs in the plant or the drive. If an error
occurs in a frequency inverter, the error signal can be transmitted via a bus system
and the required reaction can be triggered in another frequency inverter. Parameter
External error
trigger the external error.
Via parameter
be configured.
Operation mode 535
0 - Disabled
1 - Error-Switch-Off
2 - Shutdown, Error
Emergency-Stop,
3 -
Error
For setting up external warnings parameters
1364 can be used. Check chapter 15.3.9 „Application warning mask" for fur-
ing 2
ther details.
200
Handshake Traverse Function
Warnings Application
183 can be assigned the logic signal or digital input signal which is to
Operation mode ext. error
No response to external errors.
The drive is switched off and the error message „F1454
External Error" is output if the logic signal or digital input
signal for parameter
The drive is stopped at the current deceleration ramp and
the error message „F1454 External Error" is output if the
logic signal or digital input signal for parameter
183 is present.
Error
The drive is stopped at the current emergency stop ramp
and the error message „F1454 External Error" is output if
the logic signal or digital input signal for parameter
183 is present.
nal Error
Operating Instructions ACU
49, the signal source is selected for
Operation mode
1363 and
User Warning 1
273 and can be transmitted to a high-
Create warning mask application
535, the response to an external error can
Function
183 is present.
External Error
1363 and
User Warning 1
435.
User Warn-
External
Exter-
User Warn-
06/13