Warning Mask - BONFIGLIOLI ACTIVE Cube ACU 201-01 Operating Instructions Manual

15.3.8 Warning Mask

The Warning mask signals via a digital signal if an afore configured warning applies.
The configuration of the Warning mask is carried out via
Warnings and controller status messages can be combined. This enables internal or
external control using a common output signal. The display of
Controller Status
Select a setting 1 ... 43 for message activation.
Select a setting 101 ... 143 for deactivation of a message.
Create Warning Mask
0 - No Change
1 - Activate everything
2 - Activate all Warnings
Activate all Controller
3 -
States
10 - Warning Ixt
11 - Warning Short-Term Ixt
12 - Warning Long-Term Ixt
Warning Heat Sink
13 -
Temperature
Warning Inside Tem-
14 -
perature
15 - Warning Limit
16 - Warning Init
Warning Motor Tem-
17 -
perature
Warning
18 -
Mains Failure
Warning Motor Protec-
19 -
tive Switch
20 - Warning Fmax
Warning
21 -
Analog Input MFI1A
Warning
22 -
Analog Input EM-S1INA
Warning
23 -
System bus
24 - Warning Udc
25 - Application Warning
Controller
30 -
Udc Dynamic Operation
31 - Controller Shutdown
32 - Controller Mains Failure
Operating Instructions ACU
06/13
275 is not affected by the Warning mask.
536
Configured warning mask is not modified.
The warnings and controller status messages stated
are linked in the warning mask.
The warnings reports stated are linked in the warn-
ing mask.
The controller status reports stated are linked in the
warning mask.
The frequency inverter is overloaded.
Overload reserve for 1 s less the
short-term Ixt
Overload reserve for 60 s less the
long-term Ixt
Max. heat sink temperature T
Warning Limit Heat Sink Temp.
reached.
Max. inside temperature T
Warning Limit Inside Temp.
The controller stated in
the reference value.
Frequency inverter is being initialized.
Warning behavior according to parameterized
ation mode Motor temperature
temperature T
Phase monitoring
Operation Mode
switch has triggered.
The
Maximum frequency
The frequency limitation is active.
The input signal is lower than 1 V/2 mA according to
the operation mode
The input signal on the analog input of an expansion
module is lower than 1V/2mA according to the oper-
ation mode
A slave on the system bus reports a fault;
warning is only relevant with the EM-SYS option.
The DC link voltage has reached the type-dependent
minimum value.
A warning application is signaled.
Controller is active according to the
670 for the voltage controller.
The output frequency in the case of a power failure
is below the
Failure of the mains voltage and power regulation
active according to
voltage controller.
Create warning mask
Warning
Function
Warning limit
405 has been reached.
Warning limit
406 has been reached.
of 80 °C minus the
K
407 has been
of 65 °C minus the
i
408 reached.
Controller status
570 at max. motor
.
PTC
576 reports a phase failure.
571 for the motor protective
419 has been exceeded.
Error/Warning Behavior
Error/Warning Behavior
Operation Mode
675.
Shutdown threshold
Operation Mode
536.
269 and
355 limits
Oper-
453.
453.
670 for the
187