Storage And Shipment - HP 8902A Quick Reference Manual

Installation
Model 8902A
Steps for Installation Follow the procedure below to reinstall the Operaling Znjormalion
pull-out card assembly:
1. Install the information card by bowing it slightly in the middle and carefully guiding
the edges into the plastic guide slots near the front of the tray.
2. Push the information card all the way into the tray.
3. Place the information tray assembly between the rear feet of t h e instrument and slide
it forward until the tabs are locked under the rear feet.
4. Replace the front feet of the instrument.
2-4. STORAGE AND SHIPMENT
Environment
The instrument should be stored in a clean, dry environment. The following environmental
limitations apply to both storage and shipment:
Temperature
...................................... -55°C
to
+75OC
Humidity
.............................................
<95% relative
Altitude
................................ .I5 300
meters (50 000 feet)
Packaging
Original Packaging Containers and materials identical to those used in factory packaging
are available through Hewlett-Packard offices. If the instrument is being returned to Hewlett-
Packard for servicing, attach a tag indicating the type of service required, return address,
model number and full serial number. Also mark the container FRAGILE to assure careful
handling. In any correspondence refer to the instrument by model number and full serial
number.
Other Packaging
The following general instructions should be used for re-packaging with
commercially available materials:
1. Wrap the instrument in heavy paper or plastic. (If shipping to a Hewlett-Packard office
or service center, attach a tag indicating the service required, return address, model
number and full serial number.)
2. Use a strong shipping container. A double-wall carton made of 2.4 MPa (350 psi) test
material is adequate.
3. Use enough shock-absorbing material
(75 to 100
mm layer; 3 to 4 in.) around all sides
of instrument to provide firm cushion and prevent movement in the container. Protect
the front panel with cardboard.
4. Seal the shipping container securely.
5. Mark the shipping container FRAGILE to assure careful handling.
W V .
16JUNE86
2-9