Tektronix MSO70000 Series Technical Reference page 79

Table 2-1: Analog channel input and vertical specification (cont.)
Characteristic Description
Offset ranges, Volts/div setting
minimum
1 mV/div to 50 mV/div
50.5 mV/div to 99.5 mV/div
100 mV/div to 500 mV/div
505 mV/div to 995 mV/div
1 V/div to 5 V/div
5.05 V/div to 10 V/div
For 50 Ω path, 1 V/div is the maximum vertical setting.
The input signal cannot exceed Max Input Voltage for the 50 Ω input path. Refer to the Max Input Voltage
specification for more information.
Position range ±5 divisions
Offset ±[0.005 × | offset - position | + DC Balance]
accuracy
Both the position and constant offset term must be converted to volts by multiplying by the appropriate volts/div
term.
Number of 2 to 10,000 waveforms
Waveforms Default of 16 waveforms
for Average
Acquisition Mode
DC voltage Average of ≥ 16 waveforms
measurement
accuracy
Average
Delta Volts between any two averages
acquisition
of ≥16 waveforms acquired with the
mode
same oscilloscope setup and ambient
conditions
Note: Offset, position, and the constant offset term must be converted to volts by multiplying by the appropriate
volts/div term.
The basic accuracy specification applies directly to any sample and to the following measurements: High, Low,
Max, Min, Mean, Cycle Mean, RMS, and Cycle RMS. The delta volt accuracy specification applies to subtractive
calculations involving two of these measurements.
The delta volts (difference voltage) accuracy specification applies directly to the following measurements:
Positive Overshoot, Negative Overshoot, Peak-to-Peak, and Amplitude.
MSO70000/C, DSA70000B/C, DPO7000B/C, DPO7000, MSO5000, DPO5000 Series
Specifications (MSO/DPO5000 Series)
Offset range
1 MΩ input 50 Ω input
±1 V ±1 V
±0.5 V ±0.5 V
±10 V ±10 V
±5 V ±5 V
±100 V ±5 V
±50 V Not applicable
±[DC Gain Accuracy × | reading – (offset - position) | + offset
accuracy + 0.1 division ]
Refer to DC Gain Accuracy for temperature derating information.
±[DC gain accuracy × | reading | + 0.05 div]
Refer to DC Gain Accuracy for temperature derating information.
2–3