Tektronix MSO70000 Series Technical Reference page 63

Table 1-3: Trigger specifications, all MSO70000/C, DSA/DPO70000B/C, and DPO7000 Series models (cont.)
Pattern and State trigger, minimum
timing requirements, typical,
≥ 4 GHz models
Pattern type
Time qualified pattern type
State type
Period trigger sensitivity, typical
≥ 4 GHz models
< 4 GHz models
B trigger after events, minimum
timing requirements, typical,
≥ 4 GHz models
< 4 GHz models
B trigger after events, event
counter range
≥ 4 GHz models
< 4 GHz models
B trigger after time, time delay
range
≥ 4 GHz models
< 4 GHz models
Variable A event trigger holdoff
range
Lowest frequency for successful
Set Level to 50%, typical
Trigger Jitter (RMS)
≥4 GHz models
<4 GHz models
MSO70000/C, DSA70000B/C, DPO7000B/C, DPO7000, MSO5000, DPO5000 Series
Specifications (MSO70000/C Series, DSA/DPO70000B/C Series, and DPO7000 Series)
The transition trigger event occurs at the end of the transition. The logic condition must be
valid at the moment the transition event occurs minus the setup time plus the hold time.
Minimum pulse
width
150 ps
150 ps
1.7 GHz
1.5 divisions (at input connector)
1.0 division (at input connector)
Minimum pulse
width
140 ps
Minimum pulse width
200 ps
1 to 2,000,000,000
1 to 10,000,000
3.2 ns to 3 Ms
5 ns to 250 s
250 ns to 12 s + random holdoff
50 Hz
100 fs using enhanced Trigger placement. 1.0 ps RMS (typical) for low frequency, fast rise
time signal, A edge, time holdoff = 30 μs.
1.5 ps RMS (typical)
Minimum rearm
Setup time
time
200 ps N.A.
300 ps N.A.
N.A. 25 ps
Maximum Minimum time between channels
counting
frequency
3.5 GHz 1 ns
Minimum time between channels
1 ns
Hold time
N.A.
N.A.
100 ps
1–47