Table of Contents
Advertisement
4. Remove the JP1 jumper/fuse, refer to
DISTRIBUTION
subsection.
5. Measure the voltage on headlight connector as
follows.
SWITCH
WIRE COLOR
POSITION
LO beam
GREEN
(Low beam
connector)
HI beam
LO beam
BLUE
(Hi beam
HI beam
connector)
Replacing the Headlight Bulb
NOTICE
Never touch glass portion of a halo-
gen bulb with bare fingers, it shortens its oper-
ating life. If glass is touched, clean it with iso-
propyl alcohol which will not leave a film on
the bulb.
1. Unplug connector from bulb.
2. Rotate bulb.
vmo2012-012-060_b
TYPICAL
3. Pull bulb out.
4. Properly reinstall removed parts in the reverse
order of their removal.
5. Validate headlight operation.
Adjusting the Headlamp Beam
NOTE: Load vehicle as per normal use.
1. Position vehicle on a level surface 5 m (16 ft) in
front of a test surface ( wall or screen) as in first
illustration.
vmr2016-410
Subsection 07 (LIGHTS, GAUGE AND ACCESSORIES)
POWER
VOLTAGE
Battery
voltage
No voltage
BLACK
No voltage
Battery
voltage
2. Measure the distance from the center of each
headlight to the ground (high beam and low
beam).
3. Trace a line on the test surface parallel to the
ground at each measured height (one for high
beam and one for low beam).
Low beam aiming is correct when the crest of the
low beam is below the applicable horizontal cen-
ter line traced on the test surface as per specifi-
cation.
High beam aiming is correct when the center of
the high beam (focus point) is below the applica-
ble horizontal center line traced on the test sur-
face as per specification.
SPECIFICATION
Low beam crest (top
of low beam)
High beam center
(focus point)
vmr2006-020-002_a
TYPICAL
1. Light beam center
A. 5 m (16 ft)
B. Beam aiming specification
vmr2006-020-001_a
TYPICAL
1. Headlight center lines
2. Light beam center
Beam Aiming Adjustment
Turn adjustment knobs to adjust beam height and
side orientation to specification.
25 mm to 125 mm
(1 in to 5 in) below
applicable line
90°
A
B
1
90°
2
1
90°
11
Advertisement
Table of Contents
Troubleshooting
