Can-Am Renegade 570 2016 Service Manual page 234

Subsection 13 (GEARBOX AND 4X4 COUPLING UNIT (WITH GBPS))
REQUIRED TOOL
FLUKE 115 MULTIMETER
(P/N 529 035 868)
Unplug actuator connector.
Turn ignition key ON.
Set emergency engine stop switch to RUN.
Measure voltage as follows.
SWITCH
SWITCH WIRE
POSITION
2WD WHITE/BLUE
4WD WHITE/BLACK
If the selector is out of specifications, check
wires, connectors and replace the selector if nec-
essary.
If the selector is good, check the vehicle harness.
If the vehicle harness is good, replace the actua-
tor.
Removing the 4WD Actuator
NOTE: Clean area of dirt before removing the
4WD actuator.
Make sure the actuator is in 4WD position.
Remove the RH floorboard.
Place a drain pan under actuator.
Remove actuator screws.
Tmr2011-016-025_a
1. Actuator
2. Washer
3. Screw
Pull the actuator out of housing.
Installing the 4WD Actuator
Lubricate actuator O-ring.
10
VOLTAGE
Battery
WHITE
voltage
ACTUATOR O-RING
Service product
Vmr2015-123-003_a
1. Actuator O-ring
Ensure coupling fork is in 4WD position (posi-
tioned toward the front of vehicle).
Tmr2011-016-026_a
1. Coupling fork in 4WD position
Align the actuator fork with the pin on coupling
fork then push the actuator in the housing. See
the following illustration to position the actuator
correctly.
SUPER LUBE GREASE
(P/N 293 550 030)
vmr2016-424