Can-Am Renegade 570 2016 Service Manual page 286

PCODE MODULE
C21E0 SCM-XMR
C21E1 SCM-XMR
vmr2015
Subsection XX (DIAGNOSTIC AND FAULT CODES)
DESCRIPTION
Pressure did not reach
to desired set point after
predefined delay
Leak in the system
Jammed compressor
intake tube
System rear
Damaged circuit
suspension
wires or connectors
pumping delay
Blown compressor fuse
exceeded
Corroded or disconnected
compressor GND
Faulty relay
Faulty compressor
Jammed check valve
Faulty SCM
System rear
suspension high Leak in the system
leakage detected
CAUSE
1- Check for leaks. If no leak
found go to next action step.
2- Go to Activations - SCM and start
Rear Test routine. If the test is done
with no fault, the system is working
properly. Check the harness and
connector to see a potential source
of intermittent dysfunction, if nothing
is found clear the occurred fault and
no more actions have to be done.
If the compressor is not starting
check the compressor GND, harness
and connection then continue
to the next action step. If the
compressor is running and the Test
Status show a Fail_Pumping_Rear
go to action step 6.
3-Test the compressor with an
external power supply (as a 12V
battery). If the compressor is
functional go to next action step.
4-Unplug the relay and make sure to
have 12V between battery negative
post and relay pin 30. If not, check
the compressor fuse and harness.
If 12V is present, test the relay.
If the relay is functional plug it
back and go to next action step.
5- Disconnect the SCM, take a
jumper wire and connect pin 8 to the
battery negative post. If then the
compressor starts, change the SCM.
6- Verify that the compressor intake
tube (transparent) is not blocked or
kinked. Unplug the SCM air tube
(yellow) and start the compressor. If
air blow out of the tube change the
SCM. If not go to next action step.
7- During the Rear Test routine
verify the pressure sensors value.
If the Shock Absorber Pressure and
Auxiliary Line Pressure is not going
up verify the first check valve at
the exit of the compressor. If only
the Shock Absorber Pressure is not
going up verify the second check
valve after green tube.
1- Verify suspension system for air
leaks.
ACTION
3