Suspension Arm Bushings Installation; Ball Joint Removal - Can-Am Renegade 570 2016 Service Manual

1
2
3
2
vsi2015-143-009_a
UPPER SUSPENSION ARM
1. Wear plates
2. Bushings
3. Sleeves
vmr2015-056-009_a
LOWER SUSPENSION ARM
1. Wear plates
2. Bushings
3. Sleeves

Suspension Arm Bushings Installation

The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Lubricate suspension arm. Refer to
MAINTENANCE PROCEDURES
BALL JOINTS

Ball Joint Removal

1. Remove suspension arm from vehicle. Refer to
SUSPENSION ARM REMOVAL
tion.
2. Remove circlip from ball joint.
vmr2015-056
vmr2015-056-010
LOWER BALL JOINT
vsi2015-143-010_a
UPPER BALL JOINT
3. Install suspension arm on a press.
NOTICE
of the ball joint will damage it.
PERIODIC
subsection.
in this subsec-
vmr2015-056-012_a
DO NOT PRESS THERE
NOTE: The
036 310)
side edge of the ball joint.
Subsection XX (FRONT SUSPENSION)
Pressing on the center or on the lip
BALL JOINT REMOVAL TOOL (P/N 529
is design to apply force only on the out-
7