Installing The Rotor - Can-Am Renegade 570 2016 Service Manual

tmr2011-012-007_a
1. Rotor
2. Oil bore
Check keyway of the rotor for wear or damages.
Check if trigger wheel teeth are bent or otherwise
damaged.
Check woodruff key and keyway on the crank-
shaft for wear or damages.
Replace parts as necessary.

Installing the Rotor

For installation, reverse the removal procedure.
However, pay attention to the following.
Use
PULLEY FLANGE CLEANER (P/N 413 711 809)
clean following parts:
– Crankshaft taper
– Oil passage in crankshaft taper
– Thread in crankshaft
– Rotor taper
– Oil bore in rotor.
NOTICE
Taper on crankshaft and rotor must
be free of grease.
tmr2011-012-008_a
1. Crankshaft (MAG side)
2. Oil passage
3. Threads
vmr2016-403
Subsection XX (MAGNETO AND STARTER)
Oil sprag clutch and install sprag clutch gear.
vmr2006-041-015_b
1. Sprag clutch
2. Sprag clutch housing
3. Sprag clutch gear
4. Apply engine oil here
Slide rotor onto crankshaft. The woodruff key and
the keyway must be aligned.
Rotate starter double gear counterclockwise to
align intermediate gear teeth with sprag clutch
gear.
to
vmr2006-041-012_b
1. Starter double gear
2. Sprag clutch gear
3. Intermediate gear
7