Cylinder Head; Inspecting And Adjusting Engine Valve Clearance; Valve Clearance - Can-Am Renegade 570 2016 Service Manual

Subsection 02 (PERIODIC MAINTENANCE PROCEDURES)
vmr2015-029-204_a
LH SIDE
1. Rear cylinder bleed screw
6. Fill cooling system until coolant comes out of
bleed screws.
7. Squeeze the top of the coolant hose between
the radiator and coolant pump several times to
bleed all air from the highest point of the hose.
8. Install bleed screws using NEW gasket rings.
9. Tighten bleed screws to specification.
TIGHTENING TORQUE
Bleed screws
10. Refill coolant tank up to MAX level mark.
11. Install cooling system pressure cap.
12. Run engine at idle with the pressure cap ON
until the cooling fan cycles on for a second
time.
13. Stop the engine and let it cool down.
14. Check coolant level in the coolant tank. Refer
VERIFYING THE ENGINE COOLANT LEVEL
to
in this subsection.
15. Add coolant if required.

CYLINDER HEAD

Inspecting and Adjusting Engine Valve
Clearance
NOTE: Check and adjust valve clearance only
when engine is cold.
1. Remove valve covers, refer to
section.
10
3.5 N•m ± 0.4 N•m
(31 lbf•in ± 4 lbf•in)
TOP END
sub-
2. Before checking or adjusting the valve clear-
ance, turn crankshaft clockwise to TDC ignition
of the respective cylinder, refer to
TIMING GEAR
in the
tion.
NOTICE
Crankshaft must be turned clock-
wise only to avoid loosening the magneto
retaining bolt.
3. Using a feeler gauge, check the valve clear-
ance.

VALVE CLEARANCE

EXHAUST
INTAKE
If the valve clearance is out of specification, adjust
valves as follows.
NOTE: Use the center value of exhaust/intake
specification to ensure a proper valve adjustment.
4. Hold the adjustment screw at the proper posi-
tion and torque the locking nut.
vmr2007-036-003_a
1. Adjustment screw
2. Locking nut
3. Feeler gauge
5. Repeat the procedure for each valve.
6. Before installing valve covers, recheck valve
clearance.
CAMSHAFT
TIMING CHAIN
subsec-
0.11 mm to 0.19 mm
(.0043 in to .0075 in)
0.06 mm to 0.14 mm
(.0024 in to .0055 in)
vmr2016-400