Can-Am Renegade 570 2016 Service Manual page 187

Subsection 11 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT)(570/850))
REQUIRED TOOL
CLUTCH HOLDER
(P/N 529 036 238)
TIGHTENING TORQUE
Step A
Driven pulley
screw
Step B
Check driven pulley end play.
SPECIFICATION
Driven pulley end play
850 Engine
Insert the sliding sheave in the fixed sheave.
Place spring behind sliding sheave and engage
spring end in the sliding sheave spring bore.
Vmr2012-018-016_a
850 ENGINE
1. Sliding sheave
2. Spring end
3. Spring bore
Place cam on the opposite end of the spring and
engage the other spring end in the cam spring
bore.
20
20 N•m ± 1 N•m
(15 lbf•ft ± 1 lbf•ft)
180° ± 5°
0 mm (0 in)
Vmr2012-018-017_a
850 ENGINE
1. Cam
2. Spring end
3. Spring bore
Install pre-assembled cam with spring and driven
pulley on countershaft end.
NOTICE
Cam must engage on countershaft
splines.
Vmr2012-018-018_a
850 ENGINE
1. Countershaft splines
2. Cam
3. Spring
4. Sliding sheave
5. Fixed sheave
With your hand, push the driven pulley onto the
shaft to compress the spring.
As you hold the pulley in, install a NEW driven pul-
ley screw and thrust washer.
NOTICE
This assembly uses a stretch screw.
Always install a NEW screw.
NOTE: Tighten the screw with your hand approx-
imately 3 to 4 turns.
vmr2016-404