Propeller Shaft U-Joint Removal; Propeller Shaft U-Joint Installation - Can-Am Renegade 570 2016 Service Manual

PARTS
Propeller shaft screw
(rear final drive side)
Propeller shaft screw
(gearbox side)
Refill rear final drive. Refer to
NANCE PROCEDURES
PROPELLER SHAFT U-JOINTS

Propeller Shaft U-Joint Removal

Remove internal snap ring from bearing caps.
V01H0YA
1. Snap ring
Support inner yoke in vice and drive other yoke
down with a soft hammer.
V01H0ZA
vmr2015-052
TORQUE
75 N•m ± 5 N•m
(55 lbf•ft ± 4 lbf•ft)
+
LOCTITE 648 (GREEN)
(P/N 413 711 400)
75 N•m ± 5 N•m
(55 lbf•ft ± 4 lbf•ft)
+
LOCTITE 648 (GREEN)
(P/N 413 711 400)
PERIODIC MAINTE-
subsection.
1
Section 07 DRIVE SYSTEM
Subsection 03 (REAR DRIVE)
Support U-joint in vice and drive inner yoke down
to remove remaining bearing caps.
Remove U-joint cross.

Propeller Shaft U-Joint Installation

Install a NEW U-joint in inner yoke.
NOTE: Position propeller shaft U-joint as shown
for proper grease fitting location.
V01H10A
Install bearing caps. Use a vise to push bearing
caps.
V01H11A
Using a suitable pusher, fully seat bearing cap on
one side.
619