Can-Am Renegade 570 2016 Service Manual page 369

1
2
A32E2SA
POSITIONING THE CRIMPING PLIERS
Step 1: Press
Step 2: Rotate
After positioning the crimping pliers, crimp the ter-
minal already installed on wire.
A32E2TA
CRIMPING OF WIRE
A32E2UA
PROPERLY CRIMPED WIRE
To verify, if the wire is properly crimped, apply
some pulling force on wire and the terminal at the
same time from both directions.
NOTICE
Never weld the wire to the terminal.
Welding can change the property of the wire
and it can become brittle and break.
vmr2016-133
Subsection 02 (WIRING HARNESS AND CONNECTORS)
Install the protective heat shrink rubber tube on
the terminal. Heat the heat shrink rubber tube us-
ing the heat gun so that it grasps the wire and the
terminal.
NOTICE
shrink rubber tube has been properly installed
and no part of wire is exposed.
Make sure that the protective heat
15