Subsection 01 (ELECTRONIC FUEL INJECTION (EFI))
vmr2006-014-071_a
MANIFOLD O-RING POSITION
Carefully insert injector in manifold paying atten-
tion to the manifold O-ring.
NOTICE
Gently push O-ring in evenly all
around while inserting injector. O-ring must
be completely inserted and not visible, before
completing the insertion of the injector.
vmr2006-014-072_a
Firmly push injector until it bottoms out.
Reinstall fuel rail.
FUEL RAIL
Replacing the Fuel Rail
Removing the Fuel Rail
1. Disconnect fuel line to reach the rear injector.
FUEL TANK AND FUEL PUMP
Refer to
tion.
2. Unscrew rail retaining screws.
3. Gently pull rail off by hand.
10
vmr2006-014-073_a
To disconnect fuel rail from hose, cut clamp on
fuel hose. Refer to
for clamp removal/installation procedures.
OETIKER PLIERS (P/N 295
NOTE: If fuel rail is removed for access to fuel in-
jector, it is not necessary to cut hose clamp. Only
to replace fuel rail.
Installing the Fuel Rail
For installation, reverse the removal process how-
ever, pay attention to the following.
Install new clamps using pliers as per removal (if
fuel rail was replaced).
Apply a thin film of engine oil to injector O-rings to
ease insertion in rail.
SERVICE PRODUCT
Install fuel rail and evenly tighten screws a little at
a time each side.
Service product
Fuel rail retaining screws
NOTE: Activate fuel pump a few times to built
subsec-
fuel pressure.
FUEL TANK AND FUEL PUMP
REQUIRED TOOL
000 070)
INJECTOR O-RINGS
Lubricate with engine oil
TIGHTENING TORQUE
LOCTITE 243 (BLUE)
(P/N 293 800 060)
10 N•m ± 1 N•m
(89 lbf•in ± 9 lbf•in)
vmr2016-423