Starting System Tests; Starter Solenoid; Starter Solenoid Control Circuit; Starter Solenoid Control Power Circuit - Can-Am Renegade 570 2016 Service Manual

Subsection 05 (STARTING SYSTEM)

STARTING SYSTEM TESTS

Starter Solenoid

vmr2015-135-001_a
1. Disconnect SS1 and SS2
vmr2015-048-012_a
1. SS1
2. Activate the starter solenoid.
2.1 Apply 12Vdc to SS1
2.2 Ground SS2
vmr2015-048-003_c
SS1 IS ON THE RIGHT
3. If starter turns, verify
CONTROL CIRCUIT .
2
STARTER SOLENOID
4. If starter does not turn, verify
NOID CONTINUITY
.

Starter Solenoid Control Circuit

ECM
vmr2015-135-003_a
TEST CONDITION
Engine stop switch
Ignition switch
Start button
vmr2015-048-003_a
SS1 IS ON THE RIGHT
PROBE PROBE
SS1 SS2
SS1 BAT -
BAT +
SS2
If voltage is as per specification replace starter so-
lenoid.
If voltage is not as per specification, ver-
STARTER SOLENOID CONTROL POWER
ify
CIRCUIT STARTER SOLENOID CONTROL
or
GROUND CIRCUIT
as applicable.

Starter Solenoid Control Power Circuit

NOTE: This procedure also tests the start button.
STARTER SOLE-
5 A
F8
RUN
ON
Pressed
SPECIFICATION
Battery voltage
Battery voltage
Battery voltage
vmr2016-136