Engine Removal - Can-Am Renegade 570 2016 Service Manual

Subsection XX (ENGINE REMOVAL AND INSTALLATION)
PROCEDURES

ENGINE REMOVAL

1. Place vehicle on a workstation equipped with
an engine-lifting hoist.
2. Disconnect negative (-) cable from battery.
3. Carry out the following operations. Refer to ta-
ble.
OPERATIONS
Safely lift and support
the vehicle
Release fuel pressure
Drain engine coolant
Remove front body module
Remove RH footrest panel
Remove air filter housing
Remove muffler
Remove exhaust pipes
Remove CVT air inlet
Remove CVT air outlet
Disconnect positive (+)
starter cable
Disconnect TPS connector
Disconnect MAPTS
connector
Remove intake manifold
Remove spark plug cables
4. Remove RH footrest support.
2
REFERENCES
(SUBSECTION)
INTRODUCTION
FUEL TANK AND
FUEL PUMP
PERIODIC
MAINTENANCE
PROCEDURES
BODY
AIR INTAKE SYSTEM
EXHAUST SYSTEM
CONTINUOUSLY
VARIABLE
TRANSMISSION (CVT)
STARTING SYSTEM
ELECTRONIC FUEL
INJECTION (EFI)
INTAKE MANIFOLD
IGNITION SYSTEM
vmr2012-009-003_a
TYPICAL - OUTLANDER SHOWN
1. RH footrest support
5. Move throttle body aside to make room.
vmr2012-009-001
TYPICAL - THROTTLE BODY ATTACHED ON FRAME
6. Move master cylinder aside to make room.
vmr2012-009-002
TYPICAL - MASTER CYLINDER ATTACHED ON REAR FENDER
7. Move crankcase vent hose as illustrated.
vmr2013-009