Front Differential Assembly; Recommended Shim Thickness - Can-Am Renegade 570 2016 Service Manual

Section 06 DRIVE SYSTEM
Subsection 01 (FRONT DRIVE)
529035649
vmr2012-036-011_a
1. Pinion nut
Remove bearing and pinion gear together.
RECOMMENDED TOOLS
Pipe: 78 mm (3-1/16 in) diameter x 127 mm
(5 in) in length
Threaded rod: M10 x 1.25, 178 mm (7 in)
length
M10 x 1.25 nut
Flat bar
vmr2012-036-012_a
1. Bearing
2. Pinion gear
Remove and discard O-ring.
Remove bearing from pinion gear.
472
vmr2008-142-010_a
1. O-ring
2. Pinion gear
3. Bearing
Remove and discard the needle bearing.

Front Differential Assembly

Adjustment is required when any of the following
part is changed.
– Pinion gear
QTY
– Ring gear
– Viscolok unit
1
– Housing.
As a preliminary setup, install shim according to
1
the following table.
3

RECOMMENDED SHIM THICKNESS

1
BACKLASH
vmr2015-051-008
1. Backlash shim
Prior to finalizing assembly, proceed in this order:
– Temporarily assemble final drive using recom-
mended torques.
– Do not apply thread locker product.
– Do not install a new pinion nut.
– Check backlash.
– Check preload.
0.5 mm (.02 in)
(as a preliminary adjustment)
vmr2015-138