Can-Am Renegade 570 2016 Service Manual page 295

Subsection XX (DIAGNOSTIC AND FAULT CODES)
PCODE MODULE
P0480
ECM
P0500 DPS
P0508
ECM
P0509 ECM
P0513 ECM
12
DESCRIPTION
Blown fuse, damaged
or disconnected relay,
Radiator cooling damaged circuit wires
fan relay or connectors, damaged
ECM output pins, damaged
Relay.
No vehicle speed available
& Vehicle is in (H or
L Gear) with Engine
Invalid or missing RPM over 4000RPM.
vehicle speed Damaged Vehicle Speed
sensor circuit, Damaged
sensor, Wrong mounting
position of speed sensor.
Damaged IDLE,
Idle Air Control damaged circuit wires,
damaged connector or
System Circuit
Low damaged ECM output
pins.
Damaged IDLE,
Idle Air Control damaged circuit wires,
System Circuit damaged connector or
High damaged ECM output
pins.
A non stored access key
Invalid Access
was detected when key
Key Detected
switch was turned to ON.
CAUSE
Check fuse
Disconnect relay.
Measure resistance between
terminals 85 and 86 on relay.
(Expected value: 70 to 90 Ohms)
Measure resistance between
harness connector PF-1E and
ground. (Expected value > OPEN).
Measure resistance from harness
connector: ECM-B3 to PF1-1E
(Expected value: < 2 ohms)
Check if vehicle speed is available
in Monitoring page in BUDS.
Measure voltage between
harness connector CV-A (red)
and CV-C (ground black).
(Expected value: 11 to 13 volts)
Measure resistance from connector:
CI-9 to CV-B (pink) (Expected value:
< 5 ohms) on ATV
Make sure IDLE
connector is fully inserted.
Measure resistance from
connector: ECM-D4 to IDLE-D
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-D3 to IDLE-A
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-E4 to IDLE-B
(Expected value: < 2 ohms)
Measure resistance from connector:
ECM-C4 to IDLE-C (Expected value:
< 2 ohms)
Make sure IDLE
connector is fully inserted.
Measure resistance from
connector: ECM-D4 to IDLE-D
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-D3 to IDLE-A
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-E4 to IDLE-B
(Expected value: < 2 ohms)
Measure resistance from connector:
ECM-C4 to IDLE-C (Expected value:
< 2 ohms)
Use a stored access
key to turn key switch.
If no stored access keys are
available program one and try again
ACTION
vmr2015