Removing The Driven Pulley; Disassembling The Driven Pulley - Can-Am Renegade 570 2016 Service Manual

Subsection 11 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT)(570/850))
tmr2013-019-006_a
1. Clutch holder (P/N 529 036 238)
2. Drive pulley
DRIVEN PULLEY

Removing the Driven Pulley

1. Remove drive belt, refer to
MOVAL
in this subsection.
2. Hold the driven pulley and loosen the driven pul-
ley screw.
NOTE: Do not completely remove the driven pul-
ley screw.
REQUIRED TOOL
CLUTCH HOLDER
(P/N 529 036 238)
tmr2013-019-007_a
1. Driven pulley screw
2. Clutch holder (P/N 529 036 238)
3. Remove service tool.
4. Apply axial pressure with your hand on driven
pulley and maintain during screw removal.
14
5. Remove driven pulley screw and washer. Dis-
Hold driven pulley tight and slowly remove the
driven pulley screw to release spring tension.
Vmr2012-018-011_a
1. Driven pulley screw
2. Thrust washer
DRIVE BELT RE-
6. Remove the driven pulley with the spring and
vmr2015-035-003_a
1. Fixed sheave of driven pulley
2. Sliding sheave of driven pulley
3. Spring
4. Cam

Disassembling the Driven Pulley

Fixed Sheave
1. Remove retaining ring and lift torque gear.
card driven pulley screw.
CAUTION Driven pulley is spring loaded.
the cam.
vmr2016-404