Fuel Tank Vent Valve Installation; Inlet Check Valve Installation; Pressure Relief Valve Installation - Can-Am Renegade 570 2016 Service Manual

vmr2015-130-002_e
1. Inlet check valve
2. Fuel pump vent inlet fitting
3. Install small hose pincher here
2. Set vacuum/pressure pump to PRESSURE and
activate pump. The gauge should increase in
reading.
3. Set vacuum/pressure pump to VACUUM and
activate pump. The gauge on the pump should
not change in reading.
If the test failed, carry out the following:
– Ensure pressure relief valve is properly in-
stalled, refer to PRESSURE RELIEF VALVE
INSTALLATION in this subsection.
– Replace pressure relief valve if it fails the test.
vmr2015-130-002_f
1. Pressure relief valve flow direction arrow

Fuel Tank Vent Valve Installation

Inlet Check Valve Installation

Ensure white portion of inlet check valve is to-
wards the vent breather filter.
vmr2016-409
Subsection 02 (FUEL TANK AND FUEL PUMP)
vmr2015-130-002_g
1. Vent breather filter
2. White portion of inlet check valve

Pressure Relief Valve Installation

Ensure pressure relief valve flow arrow is pointing
away from fuel pump vent fitting.
vmr2015-130-002_f
1. Pressure relief valve flow direction arrow
19