Fuel Injector Leak Test; Testing The Fuel Injector Input Voltage - Can-Am Renegade 570 2016 Service Manual

Subsection 01 (ELECTRONIC FUEL INJECTION (EFI))
– Engine number (do not enter the "M" at the
beginning of the engine number)
– Enter model number.
– Customer name.
smr2009-030-007_a
VEHICLE TAB
9. Click on the following tabs:
– History
– Part Replacement
– Add Part in History.
10. Enter the old ECM serial number in the Add
Part In History window.
tmr2011-022-017_a
ADDING PART IN HISTORY
1. History tab
2. Part Replacement tab
3. Add part in history button
4. ECM selection
5. Add ECM serial number here
NOTE: The ECM serial number can be found on
the ECM sticker that also identifies the part num-
ber.
11. Click on the OK button.
12. Click on the Write Data button.
8
vmr2006-012-100_ben
FUEL INJECTOR
Refer to the applicable
SYSTEM
subsection for component and connec-
tor locations.

Fuel Injector Leak Test

FUEL PUMP PRESSURE TEST
Carry out the
FUEL TANK AND FUEL PUMP
detailed in the
section.

Testing the Fuel Injector Input Voltage

Disconnect the fuel injector electrical connector.
Turn on ignition switch.
Set emergency engine stop switch to RUN.
NOTE: Ensure to read voltage before ECM auto-
matically turns off.
Use a multimeter and set it to Vdc. Read voltage.
INJECTOR
CONNECTOR
CYLINDER
WIRE
FRONT INJ1-2
REAR INJ2-2
vmr2006-014-075_a
TYPICAL
ENGINE MANAGEMENT
as
sub-
MEASUREMENT
BAT2
Battery voltage
(-)
vmr2016-423