Replacing The Brake Fluid; Brake Fluid Filling; Draining The Brake Fluid - Can-Am Renegade 570 2016 Service Manual

Subsection 02 (PERIODIC MAINTENANCE PROCEDURES)
NOTICE
Brake pads must always be replaced
in pairs.
Brake Caliper
1. Remove caliper then check the following com-
ponents:
– Check brake pad pin
– Check caliper boots for cracks
– Check caliper movement on its support
– Check pistons movement
– Check pistons for scratches, rust or other
damages.
2. Clean the following components using the rec-
ommended product or an equivalent:
– Brake pads
– Caliper support and slider
– Caliper pistons and pin.
NOTE: Do not remove pistons from caliper for
cleaning them.
3. Lubricate caliper slider using an appropriate
BRAKE CALIPER SYNTHETIC GREASE
Brake Disc
1. Check brake disc as follows:
– Check disc thickness
– Check disc surfaces
– Check disc warpage.
BRAKE DISC INSPECTION
NOTE: Refer to
BRAKES
subsection for details.
2. Clean brake disc using the recommended prod-
uct or an equivalent.
Master Cylinder
1. Check master cylinder as follows:
– Leaks or damages.
– Brake fluid level.
– Check cleanliness of master cylinder rod and
boot.
– Check master cylinder boot for cracks or
damage. Replace as necessary.
Hand Lever
Check hand lever as follows:
– Lever pivot bolt cleanliness
– Lever pivot bolt movement.
Brake Pedal
1. Check brake pedal as follows:
– Brake pedal pivot movement
– Brake pedal pivot cleanliness.
22
2. If required, clean then lubricate brake pedal
pivot using
.
550 010)
Brake Hoses
1. Check hoses for leaks, crushed, deformations,
cracking or scrapes.
NOTE: Any deformation can restrict the proper
flow of fluid and cause braking problems.

Replacing the Brake Fluid

Draining the Brake Fluid

1. Clean and remove reservoir cover with its di-
aphragm.
2. Connect a clear hose onto bleeder.
.
in
tmr2011-037-101_a
TYPICAL
1. Caliper bleeder
3. Loosen bleeder.
4. Pump brake lever(s) and/or brake pedal until no
more fluid flows out.
5. Repeat draining procedure for the other bleed-
ers.
NOTE: To locate all bleeders according to ve-
hicle configuration, refer to
BRAKE CIRCUIT CONFIGURATIONS
and
BRAKES
subsection.

Brake Fluid Filling

1. Add recommended brake fluid to MAX. mark.
Do not overfill.
NOTE: If applicable, ensure filler cap diaphragm is
fully retracted before closing the cap.
RECOMMENDED BRAKE FLUID
BRAKE FLUID GTLMA DOT4 (P/N 293 600 131)
XPS SYNTHETIC GREASE (P/N 293
EXPLODED VIEW
. See
vmr2016-400