Can-Am Renegade 570 2016 Service Manual page 186

Subsection 11 (CONTINUOUSLY VARIABLE TRANSMISSION (CVT)(570/850))
570 Engine
Install cam on countershaft.
NOTICE
Cam splines must engage on coun-
tershaft splines.
REQUIRED PRODUCT
Countershaft splines
and countershaft
end
Vmr2012-018-014_a
TYPICAL
1. Countershaft splines
2. Cam splines
A. Loctite 767 here
Insert sliding sheave in fixed sheave.
Place spring behind sliding sheave then align
driven pulley with cam.
Vmr2012-018-015_a
TYPICAL
1. Cam
2. Spring
3. Sliding sheave
4. Fixed sheave
With your hand, push the driven pulley onto the
shaft to compress the spring.
vmr2016-404
LOCTITE 767
(ANTISEIZE LUBRICANT)
(P/N 293 800 070)
NOTICE
A cam not correctly engaged will
cause damage to the driven pulley and cam.
As you hold the pulley compressed, install a NEW
driven pulley screw and thrust washer.
NOTICE
This assembly uses a stretch screw.
Always install a NEW screw.
NOTE: Tighten the screw with your hand suffi-
ciently for the cam to remain engaged.
Vmr2012-018-011_a
1. Driven pulley screw
2. Thrust washer
Install drive belt. Refer to
section.
REQUIRED TOOL
PULLER/LOCKING
TOOL
(P/N 529 036 098)
Vmr2012-018-022_a
1. Puller/locking tool
2. Sliding sheave
NOTE: If driven pulley sheaves cannot be opened
when the service tool is screwed in, the cam is not
correctly engaged in the sliding sheave.
Tighten driven pulley screw to specification.
DRIVE BELT in this sub-
19