Can-Am Renegade 570 2016 Service Manual page 307

Subsection XX (DIAGNOSTIC AND FAULT CODES)
PCODE MODULE
U0073 ECM
U0100 DPS
U0155 DPS
U0155
ECM
24
DESCRIPTION
CAN bus off, no Damaged circuit wires or
messages damaged CLUSTER pins.
Lost
Damaged CAN Bus
communication
wires to ECM, damaged
with ECM (lost of
DPS/ECM pins.
CAN ID's)
Damage CAN Bus
Lost wires to cluster
communication Damaged circuit wires or
with CLUSTER
damaged Cluster module
pins.
Missing CLUSTER CAN ID
Lost
Module internal error
communication
Damaged circuit wires or
with CLUSTER
damaged module pins.
CAUSE
Disconnect MPI2 from DB connector.
Measure resistance between
DB-1 and DB-2 (Expected
value = 50 to 70 ohms).
Measure resistance
between DB-1 and ECM-B1
(Expected value < 2 ohms).
Measure resistance between DB-2
and ECM-C1 (Expected value < 2
ohms).
Disconnect MPI2 from DB connector.
Measure resistance between
DB-1 and DB-2 (Expected
value = 50 to 70 ohms).
Measure resistance
between DB-1 and ECM B1
(Expected value < 5 ohms).
Measure resistance between DB-2
and ECM C1 (Expected value < 5
ohms).
Measure voltage between harness
connector CL-17 and ground.
(Expected value = 11 to 13 volts)
Disconnect MPI2 from DB connector.
Measure resistance between
DB-1 and DB-2 (Expected
value = 50 to 70 ohms).
Measure resistance between DB-1
and CL-4 (Expected value < 5 ohms).
Measure resistance between DB-2
and CL-19 (Expected value < 5
ohms).
Measure voltage between harness
connector CL-17 and ground.
(Expected value = 11 to 13 volts)
Disconnect MPI2 from DB connector.
Measure resistance between
DB-1 and DB-2 (Expected
value = 50 to 70 ohms).
Measure resistance
between DB-1 and ECM-B1
(Expected value < 2 ohms).
Measure resistance
between DB-2 and ECM-C1
(Expected value < 2 ohms).
Measure resistance between DB-1
and CL-19 (Expected value < 2 ohms).
Measure resistance between DB-2
and CL-18 (Expected value < 2
ohms).
ACTION
vmr2015