Front Differential Installation - Can-Am Renegade 570 2016 Service Manual

Visco-Lok Carrier/Ring Gear
The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
Tighten Visco-Lok / ring gear screws to specifica-
tion.
TIGHTENING TORQUE
Visco-Lok / ring gear
screws
Check condition of seal. Replace if damaged.
vmr2015-051-003_a
Check bearings. Replace with NEW bearings if
necessary.
vmr2015-051-004_a
Apply
XPS SYNTHETIC GREASE (P/N 293 550 010)
NEW oil seals and install.
vmr2015-138
37 N•m ± 3 N•m
(27 lbf•ft ± 2 lbf•ft)
on
Section 06 DRIVE SYSTEM
Subsection 01 (FRONT DRIVE)
vmr2015-051-001_a
Tighten differential housing screws to specifica-
tion.
TIGHTENING TORQUE
Differential housing
screws
Pinion Gear
Install a NEW ball bearing.
Install a NEW O-ring.
Install a NEW needle bearing.
Apply
LOCTITE 277 (P/N 293 800 073)
Install and tighten the pinion nut to specification.
TIGHTENING TORQUE
Pinion nut
Apply
XPS SYNTHETIC GREASE (P/N 293 550 010)
NEW oil seal and install.
Tighten front propeller shaft adapter retaining
screw to specification.
TIGHTENING TORQUE
Front propeller shaft
adapter retaining screw

Front Differential Installation

The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
When inserting the small portion of propeller shaft
into propeller shaft boot, make sure both parts of
propeller shaft are well indexed.
23.5 N•m ± 3.5 N•m
(17 lbf•ft ± 3 lbf•ft)
to pinion nut.
180 N•m ± 15 N•m
(133 lbf•ft ± 11 lbf•ft)
+
LOCTITE 277 (P/N 293
800 073)
on
75 N•m ± 5 N•m
(55 lbf•ft ± 4 lbf•ft)
473