Fuel Tank Inspection; Fuel Tank Installation - Can-Am Renegade 570 2016 Service Manual

Subsection 02 (FUEL TANK AND FUEL PUMP)
vmr2012-028-018_a
1. Rear frame extension
2. Loosen these 2 nuts
3. Remove these 4 bolts
17. Remove nuts and screws securing final drive
protector and rear frame support to rear final
drive.
vmr2012-028-024_a
1. Final drive protector
18. Remove rear frame supports as an assembly.
vmr2012-028-020_a
1. Upper frame support (welded)
2. Lower frame support
3. Bolts to remove
10
19. Lift up on frame extension and pull fuel tank
out of vehicle.
NOTE: When lifting up on the frame extension,
the shock absorbers will fall backwards.
vmr2012-028-021_a
1. Rear shock absorbers
2. Fuel tank

Fuel Tank Inspection

Inspect fuel tank for any damages or cracks which
may result in fuel leaks.
Inspect fuel tank and fuel tank protector on frame
for damages.
Inspect protector for damages.
If cracks, gouges or other damages which may
lead to a fuel leak, or damages to attachment
points that could prevent the tank from being
secure are found, replace fuel tank.

Fuel Tank Installation

Installation is the reverse of the removal proce-
dure. However, pay attention to the following.
Install a bushing on each fuel tank mounting
screw. The bushing inserts within the fuel tank
screw hole cavity.
Be sure to install the washers between the fuel
tank and the fastener as noted at removal.
Install all fuel tank fasteners loosely.
NOTICE
The fuel tank fasteners must not be
tightened to specified torque until complete as-
sembly in vehicle.
Install all frame component fasteners loosely,
then apply torque as specified in the
subsection.
Apply specified torque to fuel tank retaining
screws.
FRAME
vmr2016-409