Can-Am Renegade 570 2016 Service Manual page 301

Subsection XX (DIAGNOSTIC AND FAULT CODES)
PCODE MODULE
P0707
ECM
P0708 ECM
P1562 ECM
P1563 ECM
P1619
ECM
18
DESCRIPTION
Gear position
sensor shorted to
ground, or open
circuit
Gear position
sensor circuit
shorted to battery
+
Blown fuse FC,
battery failure, voltage
regulator failure,
System voltage
damaged circuit wires
low (from Key
or connection, damaged
switch)
magneto generator.
An external battery charger
may have been used.
System voltage Damaged regulator.
high (from Key An external battery charger
switch) may have been used.
Wrong throttle body
mechanical position during
TPS adaptation
reset of closed TPS
failure
or no initialization after
ECM replacement.
CAUSE
Verify that gear position information
change when you change the
position of gear on vehicle.
Disconnect GBPS
Measure voltage between harness
connector GBPS-1 and GBPS-3.
(Expected value: 4.8 to 5.1 volts)
Measure resistance from
connector: ECM-D2 to GBPS-2
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-C3 to GBPS-3
(Expected value: < 2 ohms)
Replace GBPS sensor
Verify that gear position information
change when you change the
position of gear on vehicle.
Disconnect GBPS
Measure voltage between harness
connector GBPS-1 and GBPS-3.
(Expected value: 4.8 to 5.1 volts)
Measure resistance from
connector: ECM-D2 to GBPS-2
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-C3 to GBPS-3
(Expected value: < 2 ohms)
Replace GBPS sensor
Measure battery voltage with
engine stopped. (Expected
value: 11 to 13 volts)
Measure battery voltage with
engine running. (Expected
value: 13 to 14.7 volts)
Check connections
on voltage regulator.
Check ground and positive
connections on battery.
Check ground on vehicle frame
Measure battery voltage with
engine stopped. (Expected
value: 11 to 13 volts)
Measure battery voltage with
engine running. (Expected
value: 13 to 14.7 volts)
Check connections
on voltage regulator.
Check ground and positive
connections on battery.
Check ground on vehicle frame
Replace gauge if necessary.
ACTION
vmr2015