Magneto Cover Access; Removing The Magneto Cover; Inspecting And Cleaning The Magneto Cover - Can-Am Renegade 570 2016 Service Manual

PROCEDURES
MAGNETO COVER

Magneto Cover Access

BODY
Refer to the subsection and remove the fol-
lowing part.
vmr2016-403-001
ENGINE WITH 420W MAGNETO
vmr2016-403-002
ENGINE WITH 650W MAGNETO

Removing the Magneto Cover

Drain engine oil (refer to
PERIODIC MAINTENANCE PROCEDURES
in the
subsection).
Remove crankshaft position sensor (CPS) and cut
tie raps.
Disconnect the stator connector on the voltage
regulator/rectifier, refer to
ACCESS in this subsection.
Remove dipstick with O-ring.
vmr2016-403
ENGINE OIL CHANGE
STATOR CONNECTOR
Subsection XX (MAGNETO AND STARTER)
vmr2015-030-002_a
1. Dipstick
2. O-ring
3. Crank position sensor (CPS)
Remove magneto cover retaining screws.
vmr2015-030-003_a
1. Magneto cover
2. Retaining screws
Pull out magneto cover.
Inspecting and Cleaning the Magneto
Cover
Check magneto cover for cracks or other damage.
Replace if necessary.
NOTE: Clean all metal components in a non-
ferrous metal cleaner. Use
KET REMOVER) (P/N 413 708 500)
equivalent.
WARNING
Wear safety glasses and work in a well
ventilated area when working with strong
chemical products.
non-absorbent gloves to protect your hands.
LOCTITE CHISEL (GAS-
, or suitable
Also wear suitable
3