Fuel Pump Pre-Filter Replacement - Can-Am Renegade 570 2016 Service Manual

TIGHTENING TORQUE
Fuel pump retaining nut
7. Install fuel pressure hose on fuel pump using a
NEW Oetiker clamp.
8. Install fuel vent tube on fuel pump.
9. Install electrical connector on fuel pump.
10. Install fuel pump relay (R4).
11. Refuel tank and ensure there are no leaks by
FUEL TANK LEAK TEST
performing a
FUEL PUMP PRESSURE TEST
this subsection.
12. Check fuel level sender operation.
FUEL PUMP PRE-FILTER
(STRAINER)

Fuel Pump Pre-filter Replacement

(570 Engine)
FUEL PUMP
1. Remove
MOVAL
in this subsection.
2. Unlock 3 tabs on strainer plastic ring.
vmr2015-043-027_a
3. Remove rubber pad.
vmr2016-409
29 N•m ± 1 N•m
(21 lbf•ft ± 1 lbf•ft)
and a
as described in
FUEL PUMP RE-
, see
Subsection 02 (FUEL TANK AND FUEL PUMP)
vmr2015-043-028_a
4. Remove push nut securing strainer to fuel
pump. Be careful not to break the assembly
locator pin.
vmr2015-043-029_a
5. Pull strainer off fuel pump.
vmr2015-043-030_a
15