Winch Wire Identification; Winch Switch Circuit Protection; Removing The Winch; Winch Switch - Can-Am Renegade 570 2016 Service Manual

Subsection 07 (LIGHTS, GAUGE AND ACCESSORIES)
WINCH

Winch Wire Identification

WINCH RELAY
FUNCTION
12 volt input from battery
(winch power)
Ground
12 volt input from
switch (IN)
12 volt input from
switch (OUT)
Motor power (switches
polarity depending on
rotation direction)
Motor power (switches
polarity depending on
rotation direction)
NOTE: The small black wire at terminal BN4 con-
nected to the diodes are used to prevent electric
arcs in the switch.

WINCH SWITCH

FUNCTION
12 volt input from fuse 7
12 volt output to relay
winding (IN)
12 volt output to relay
winding (OUT)
WARNING
Before testing, make sure the winch is in
FREESPOOL mode (Freespool clutch disen-
gaged).
14
PIN COLOR
RD RED
SW4 BLACK
SW1 GREEN/BLUE
SW2 LIGHT BLUE
RED (with blue
SW3
sleeve)
RED (with
SW5
yellow sleeve)
PIN COLOR
A
RED/BLACK
C GREEN/BLUE
B
LIGHT BLUE
tmr2011-030-003_a
SIMPLIFIED WINCH WIRING DIAGRAM
1. Winch motor
2. Winch relay
3. Winch remote control
4. Winch switch
5. Battery
6. 12 volt input to switch (switch pin 2 - from fuse 7)
7. Winch motor power (SW3)
8. Winch motor power (SW5)
9. 12 volt input to relay winding (IN - SW1)
10. 12 volt input to relay winding (OUT - SW2)

Winch Switch Circuit Protection

CONDITION
Supplied when
accessories relay
activated

Removing the Winch

1. Disconnect, the battery BLACK (-) cable first,
then the RED (+) cable.
WARNING
Always respect this order for disassembly;
disconnect BLACK (-) cable first.
2. Remove the hook.
2.1 Remove and discard the cotter pin.
2.2 Remove the hook pin.
CIRCUIT PROTECTION
Fuse 7 (from accessories
relay R3)
vmr2016-410