Bulb Replacement - Can-Am Rally 200 Operator's Manual

1
V06G01Y
1. Fuse holder
To remove fuse from holder, unclip
and remove holder cover then pull
fuse out. Check if filament is melted.
A15E0KY
1. Fuse
2. Check if melted

Bulb Replacement

WARNING
Always turn the ignition switch to
OFF position before replacing a de-
fective bulb.
Always check light operation after re-
placement.
_____________________
114
Headlamp
CAUTION: Never touch glass por-
tion of an halogen bulb with bare
fingers, it shortens its operating
life. If glass is touched, clean it
with isopropyl alcohol which will
not leave a film on the bulb.
To unplug connector, release outer
edge of rubber protector from head-
lamp housing, then pull on connector
using a wiggle movement.
NOTE: The rubber protector is a one-
piece component, encapsulating the
connector.
1
2
vmo2006-001-008_a
1. Release outer edge of rubber protector
2. Pull on connector using a wiggle movement
NOTE: Concerning the following illus-
trations, the front fascia has been re-
moved from the vehicle for a better
comprehension.
Press the spindle then push it on the
side to unlock headlamp bulb.