Bulb Replacement - Can-Am 2008 DS 450 Operator's Manual

vmo2008-011-081_a
DESCRIPTION
1. Fan (5 A)
2. ECM (Engine Control Module) (10 A)
3. Main (20 A)
Fuse Inspection/Replacement
To remove fuse from holder, pull fuse
out. Check if filament is melted.
TYPICAL
1. Fuse
2. Check if melted

Bulb Replacement

WARNING
Always turn the ignition switch to
OFF position before replacing a de-
fective bulb.
Always check light operation after re-
placement.
vmo2008-011-045_a
1. Bulb location
Headlamp
CAUTION: Never touch glass por-
tion of an halogen bulb with bare
fingers, it shortens its operating
life. If glass is touched, clean it
with isopropyl alcohol which will
not leave a film on the bulb.
Remove rubber booth then unplug
bulb connector.
vmo2008-011-046_a
Rotate bulb counterclockwise.
vmo2008-011-047_a
Replace defective bulb.
_____________________
119