Drive Shaft Removal; Drive Shaft Inspection; Drive Shaft Installation - Can-Am Renegade 570 2016 Service Manual

Section 07 DRIVE SYSTEM
Subsection 03 (REAR DRIVE)
TIGHTENING TORQUE
Wheel hub nut
NOTE: If required, tighten castellated nut further
to align grooves with drive shaft hole.
Install a NEW cotter pin.
tmr2011-032-005
DRIVE SHAFT

Drive Shaft Removal

vmr2012-037-014_a
TYPICAL
1. Drive shafts
Lift and support vehicle.
Remove the wheel hub. See procedure in this
subsection.
Remove trailing arm. Refer to
SION
.
Strongly pull drive shaft out of final drive.
616
205 N•m ± 15 N•m
(151 lbf•ft ± 11 lbf•ft)
REAR SUSPEN-

Drive Shaft Inspection

Inspect the condition of boots. If there is any dam-
age or evidence of leaking lubricant, replace them.
Refer to DRIVE SHAFT BOOT
Check shaft splines. Replace drive shaft if neces-
sary.
Check dust shield on drive shaft end. Replace if
necessary.

Drive Shaft Installation

The installation is the reverse of the removal pro-
cedure. However, pay attention to the following:
Install a NEW stop ring.
V07H0AA
TYPICAL
1. NEW stop ring
After drive shaft insertion in rear final drive, vali-
date if properly locked.
DRIVE SHAFT BOOT
Drive Shaft Boot Removal
Remove the drive shaft from vehicle. See proce-
dure in this subsection.
Remove drive shaft boot clamps using the follow-
ing tool:
TOOL
CV BOOT CLAMP PLIER
(P/N 529 036 120)
Dislodge the large boot end.
Separate the joint from the shaft. Two procedures
can be done.
Without the Special Tool
Clamp joint housing in a vise.
Align shaft with joint.
Pull hard on shaft to remove from joint.
Remove boot from drive shaft.
.
1
vmr2015-052