Starter Solenoid Control Ground Circuit; Starter Solenoid Continuity - Can-Am Renegade 570 2016 Service Manual

Subsection 05 (STARTING SYSTEM)
Starter Solenoid Control Ground
Circuit
SS2-
L3
HIC1-J
B4
G2
K3
A4
vmr2015-048-005_a
1. Disconnect SS2.
2. Install the ECM connector onto the
ADAPTER TOOL (P/N 529 036 166)
vmr2008-139-016_a
1. ECM connector
2. ECM adapter tool
PROBE PROBE
SS2 ECM-L3
If resistance is not as specified, repair or replace
wiring/connections.
If solenoid power control circuit and ground con-
trol circuit both test good, test ECM ground
ELECTRONIC FUEL INJECTION
circuits. Refer to
(EFI)
subsection.
NOTE: Supply a ground with a jumper wire if you
suspect that the ECM is not supplying a ground to
the solenoid.
4

Starter Solenoid Continuity

SS1-
vmr2016-136-100_a
1. Disconnect the BLACK (-) negative battery ca-
2. Disconnect SS1 and SS2
ECM
vmr2015-048-012_a
1. SS1
SPECIFICATION
Close to 0
vmr2015-048-003_d
If resistance is not as per specification, replace the
solenoid.
3. Disconnect BP3.
ble.
PROBE PROBE
SS1 SS2
SPECIFICATION
@ 20°C (68°F)
Close to 6
vmr2016-136