Can-Am Renegade 570 2016 Service Manual page 140

vmr2015-033-005_a
1. Screw plug
2. O-ring
4. Remove the crankshaft position sensor (CPS).
vmr2015-033-006_a
1. CPS
2. Screw
5. Set rear piston no. 2 to TDC ignition by turning
the crankshaft clockwise.
REQUIRED TOOL
Allen key 14 mm
vmr2016-420
Subsection 09 (TIMING CHAIN)
vmr2015-033-007_a
TURN CRANKSHAFT CLOCKWISE TO PISTON NO. 2 TDC
1. Allen key 14 mm
5.1 The rear piston is at TDC when it's index
mark on the magneto flywheel is aligned
with the notch in the magneto cover.
vmr2007-037-008_b
PISTON NO. 2 AT TDC
1. Piston no. 2 identifier
2. Index mark on magneto flywheel
3. Notch on magneto cover
4. CPS bore in magneto cover
5.2 Confirm printed marks on the camshaft
timing gear are parallel with cylinder head
base, in the lowest position. In this posi-
tion the piston is set to TDC ignition.
NOTE: If marks on camshaft timing gear are
not as specified, turn crankshaft 360°.
7