Crankshaft Locking Procedure - Can-Am Renegade 570 2016 Service Manual

Crankshaft Locking Procedure

NOTE: When the crankshaft is locked, the rear
piston no. 2 is at TDC (top dead center). The
crankshaft cannot be locked with front piston no.
1 at TDC.
NOTICE
To see if the rear piston no. 2 is
at TDC ignition, refer to
GEAR TIMING CHAIN
in the
1. Remove spark plug cables and spark plugs from
both cylinders.
2. Remove screw plug and O-ring from magneto
cover.
vmr2015-033-005_a
1. Plug screw
2. O-ring
3. Remove crankshaft position sensor.
vmr2015-033-006_a
1. Crankshaft position sensor
2. Screw
4. Remove screw plug and discard sealing ring.
vmr2016-421
CAMSHAFT TIMING
subsection.
Subsection 10 (BOTTOM END)
vmr2015-034-005_a
1. Sealing ring
2. Plug screw
3. Crankcase PTO side, front side
5. Use a 14 mm Allen key to turn crankshaft until
the rear piston no. 2 is at TDC.
vmr2015-033-007_a
1. Allen key 14 mm
NOTE: When the piston no. 2 is at TDC, the num-
ber 2 piston index mark on the magneto flywheel
and the notch on the magneto cover are aligned.
17