Removing The Sprag Clutch Gear; Inspecting The Sprag Clutch Gear; Installing The Sprag Clutch Gear; Starter Drive Gear Location - Can-Am Renegade 570 2016 Service Manual

vmr2006-041-015_b
1. Sprag clutch
2. Sprag clutch housing
3. Sprag clutch gear
4. Apply engine oil here
ROTOR
Install rotor, refer to
Tighten sprag clutch housing screws to specifica-
tion.
TIGHTENING TORQUE
Sprag clutch housing
screws
SPRAG CLUTCH GEAR

Removing the Sprag Clutch Gear

Remove ROTOR . See procedure in this subsec-
tion.
Pull sprag clutch gear out of the rotor.
vmr2006-041-015_a
1. Rotor
2. Sprag clutch gear

Inspecting the Sprag Clutch Gear

Inspect gear, especially teeth and sprag clutch col-
lar, for wear and other damage.
vmr2016-403
in this subsection.
30 N•m ± 2 N•m
(22 lbf•ft ± 1 lbf•ft)
Subsection XX (MAGNETO AND STARTER)
Check needle bearing condition. Replace sprag
clutch gear if necessary.
vmr2006-041-016_a
INSPECT
1. Teeth
2. Collar
3. Needle bearing

Installing the Sprag Clutch Gear

The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
NOTE: Apply engine oil on needle bearing and col-
lar of sprag clutch gear.
STARTER DRIVE GEARS

Starter Drive Gear Location

The starter drive gears are located on the engine
MAG side behind the magneto cover.
Removing the Starter Drive Gear
Remove MAGNETO COVER
this subsection.
Remove location pins, starter double gear and in-
termediate gear.
. See procedure in
9