Can-Am Renegade 570 2016 Service Manual page 298

PCODE MODULE
P0617 ECM
P0636
DPS
P0637 DPS
P0642 ECM
P0643 ECM
P0658
DPS
P0659 DPS
P0666 DPS
vmr2015
Subsection XX (DIAGNOSTIC AND FAULT CODES)
DESCRIPTION
Damaged relay,
Danaged start switch,
Starter Relay
damaged circuit wires,
circuit shorted
damaged connector,
to battery +
damaged ECM pins.
MOTOR LOW Internal error or damaged
CURRENT FAULT DPS
MOTOR HIGH Internal error or damaged
CURRENT FAULT DPS
Damaged sensor
connected to ECM
Sensor Reference
voltage supply,
Voltage Low
Damaged ECM voltage
supply output.
Damaged sensor
connected to ECM
Sensor Reference
voltage supply,
Voltage High
Damaged ECM voltage
supply output.
DPS motor supply
PHASE A_LOW
Damaged DPS
DPS motor supply
PHASE A_HIGH
Damaged DPS
High temperature of the
HIGH
DPS. Extreme usage of the
TEMPERATURE
unit.
CAUSE
Check start button, Check
Run/Stop button, check if free
weeling diode is in the good way.
Disconnect starter solenoid relay
Measure resistance from harness
connector: ECM-L3 to SS2
(Expected value: < 2 ohms)
Measure resistance from harness
connector: MG2-6 to SS1
(Expected value: < 2 ohms)
Measure resistance between
terminals SS1 and SS2. (Expected
value: 3 to 6 ohms)
External troubleshooting
is not possible
Replace the DPS.
External troubleshooting
is not possible
Replace the DPS.
Measure voltage between harness
connector ECM-A1 and ground.
(Expected value: 4.8 to 5.1 volts)
Check sensor connected to ECM
voltage supply output
Measure voltage between harness
connector ECM-A1 and ground.
(Expected value: 4.8 to 5.1 volts)
Check sensor connected to ECM
voltage supply output
External troubleshooting
is not possible
Replace the DPS.
External troubleshooting
is not possible
Replace the DPS.
Let the unit cool down.
ACTION
15