Can-Am Renegade 570 2016 Service Manual page 302

PCODE MODULE
P1F01 DPS
P1F02 DPS
P1F03 DPS
P1F05
DPS
P2300 ECM
P2301 ECM
vmr2015
Subsection XX (DIAGNOSTIC AND FAULT CODES)
DESCRIPTION
Power output Motor short circuit or
overload power output failed
Power output High voltage at the unit
overload (18V). input.
Hi temperature detected
Electronic Circuit
by on board temperature
Overheat
sensor.
Motor Motor input vs output
current sensor Current correlation check
range/performance failed
Damaged ignition coil,
Cyllinder 1 damaged circuit wires,
Ignition output damaged connector or
shorted to ground damaged ECM output
pins.
Damaged ignition coil,
damaged circuit wires,
Cyllinder 1
Ignition output damaged connector or
short to V + damaged ECM output
pins.
CAUSE
Reset fault, If fault re-occur, replace
DPS unit
Measure battery voltage with
engine stopped. (Expected
value: 11 to 13 volts)
Measure battery voltage with
engine running. (Expected
value: 13 to 14.7 volts)
test charging system as per
shop manual
Fault may become Active
in extreme use situations.
Reset fault and let DPS cool down.
If fault re-occur in normal riding
conditions, replace DPS unit
External troubleshooting
is not possible
Replace the DPS.
Open the ECM
Activation page in BUDS
Perform an ignition coil
activation and check if ignition
coil is reacting as expected
Measure resistance from harness
connector: ECM-M2 to BA-3
(Expected value: < 2 ohms)
Measure voltage between harness
connector BA-2 and ground.
(Expected value: 11 to 13 volts)
Refer to the service manual
for detailed ignition coil testing
procedure.
Open the ECM
Activation page in BUDS
Perform an ignition coil
activation and check if ignition
coil is reacting as expected
Measure resistance from harness
connector: ECM-M2 to BA-3
(Expected value: < 2 ohms)
Measure voltage between harness
connector BA-2 and ground.
(Expected value: 11 to 13 volts)
Refer to the service manual
for detailed ignition coil testing
procedure.
ACTION
19