Can-Am Renegade 570 2016 Service Manual page 300

PCODE MODULE
P0691
ECM
P0692
ECM
P0705 ECM
P0706 ECM
vmr2015
Subsection XX (DIAGNOSTIC AND FAULT CODES)
DESCRIPTION
Blown fuse, damaged or
Radiator fan
disconnected fan relay,
circuit shorted
damaged circuit wires,
to ground or open
damaged connectors or
circuit
damaged ECM output pins.
Damaged fan relay,
Radiator fan damaged circuit wires,
circuit shorted damaged connector or
to battery + damaged ECM output
pins.
Wrong Switch
Subtransmission Combinations
Internal switch Damaged Switch,
Combinations damaged circuit wires,
error damaged connectors or
damaged ECM pins.
GBPS invalide GBPS position not
gear position plausible
CAUSE
Check fuse
Disconnect radiator fan relay
Measure voltage between harness
connector PF1-3D and ground.
(Expected value: 11 to 13 volts)
Measure resistance from harness
connector: ECM-B3 to PF1-1E
(Expected value: < 2 ohms)
Measure resistance between
terminals 85 and 86 on relay.
(Expected value: 70 to 90 ohms)
Check fuse
Disconnect radiator fan relay
Measure voltage between harness
connector PF1-3D and ground.
(Expected value: 11 to 13 volts)
Measure resistance from harness
connector: ECM-B3 to PF1-1E
(Expected value: < 2 ohms)
Measure resistance between
terminals 85 and 86 on relay.
(Expected value: 70 to 90 ohms)
Check for disconnected
transmission connector.
Check for misplaced
terminal on gearbox
Measure resistance form each
switch to ground in all position
(PR & N) (Expected value if
switch activated: < 2 ohms)
Measure resistance from harness
connector: ECM-J3 to PRN-1
(Expected value: < 2 ohms)
Measure resistance from harness
connector: ECM-H2 to PRN-2
(Expected value: < 2 ohms)
Measure resistance from harness
connector: ECM-H4 to PRN-3
(Expected value: < 2 ohms)
Verify that gear position information
change when you change the
position of gear on vehicle.
Disconnect GBPS
Measure voltage between harness
connector GBPS-1 and GBPS-3.
(Expected value: 4.8 to 5.1 volts)
Measure resistance from
connector: ECM-D2 to GBPS-2
(Expected value: < 2 ohms)
Measure resistance from
connector: ECM-C3 to GBPS-3
(Expected value: < 2 ohms)
Replace GBPS sensor
ACTION
17