Removing The Pto Oil Seal - Can-Am Renegade 570 2016 Service Manual

2. Remove rear bearing cover, refer to
DRIVE SHAFT REMOVAL/INSTALLATION
this subsection.
3. Remove O-ring from bearing cover.
vmr2013-018-003_a
1. Bearing cover
2. O-ring
4. Remove drive shaft seal from bearing cover.
tmr2013-018-005_a
1. Bearing cover
2. Oil seal
5. Install drive shaft oil seal using the following
tool.
REQUIRED TOOL
DRIVE SHAFT OIL SEAL
INSTALLER (P/N 529 036 028)
vmr2016-421
ENGINE
in
vmr2013-018-002_a
1. Bearing cover
2. Oil seal
3. Oil seal installer
6. Install O-ring in rear bearing cover.
vmr2013-018-004_a
1. O-ring
2. Bearing cover
7. Reinstall remaining parts in the reverse order of
removal.
PTO COVER OIL SEAL
NOTE: To replace oil seal it is not necessary to
remove engine from vehicle.

Removing the PTO Oil Seal

1. Refer to
MISSION (CVT)
lowing parts:
– CVT cover
– Drive pulley
– Driven pulley
– CVT air guide.
2. Remove oil seal using a small flat screwdriver.
Subsection 10 (BOTTOM END)
CONTINUOUSLY VARIABLE TRANS-
subsection and remove the fol-
7