Pitman Arm (With A Dps); Installing The Wheel Bearing - Can-Am Renegade 570 2016 Service Manual

V07I0RA
TYPICAL
3. Remove the circlip.
1
V07I0SA
TYPICAL
1. Circlip
tmr2011-034-015_a
TYPICAL
1. Seal
2. Circlip
4. Install knuckle on a press.
vmr2016-414
Subsection 01 (STEERING SYSTEM)
5. Remove bearing from knuckle using an appro-
priate bearing remover.
tmr2011-034-109
NOTE: It may be necessary to heat the knuckle to
remove bearing.
WARNING
Clean all grease from outside and inside of
knuckle before heating it.

Installing the Wheel Bearing

The installation is the reverse of the removal pro-
cedure. However, pay attention to the following.
To ease wheel bearing installation:
– Place bearing in a freezer for 10 minutes.
– Place knuckle in oven to 100°C (212°F) for
30 minutes maximum.
When knuckle is cooled down, install NEW circlip
and NEW seal.

PITMAN ARM (WITH A DPS)

Refer to DYNAMIC POWER STEERING (DPS)
subsection.
11